Garmin 4000 Marine GPS System User Manual


  Open as PDF
of 18
 
3GPSMAP 4000/5000 Series Installation Instructions
To ush mount the unit:
1. Theushmounttemplateisincludedintheproductbox.Trimthetemplateandensureitwilltinthelocationyouwanttoushmountthe
unit.
Make sure the surface on which you mount the unit has at least 7" (17.75 cm) of open space behind it to t the unit and the connected
wires.
Make sure to leave approximately
1
/
2
" (13 mm) of space on the right side of the unit to access the SD card door.
Mount a 4008/4208/5008/5208 unit 31
1
/
4
" (80 cm), and a 4012/4212/5012/5212 unit 39
3
/
8
"
(1 m) from a magnetic compass to avoid
interference.
2. Theushmounttemplatehasadhesiveontheback.Removetheprotectivelinerandapplythetemplatetothelocationyouwanttomount
the unit.
3. Using the center punch, indent the center of each of the 4 mm mounting hole locations.
4. Using a 4 mm drill bit, drill the four mounting holes.
5. Using a
3
/
8
" (6 mm) drill bit, drill one or more of the four pilot holes inside the corner of the template to begin cutting the mounting surface.
6. Usingthejigsaw,cutthemountingsurfacealongtheinsideofthesolidlineindicatedontheushmounttemplate.Usealeand
sandpapertorenethesizeofthehole.Be very careful when cutting this hole. There is only a small amount of clearance between
the case and the mounting holes.
7. Install the four mounting studs into the unit by screwing the shorter, threaded section into the back of the unit. Use the
1
/
16
" (2 mm) Allen
wrench to tighten the mounting studs until they stop. Do not overtighten - you may damage the mounting stud or the mounting holes.
The studs are coated with a reusable thread-locking patch applied at the factory.
8. Place the unit into the cut-out. The four mounting studs should feed through the 4 mounting holes drilled in step 3.
9. Place the flat washers, then the lock washers over the mounting studs. Thread the hex nuts onto the mounting studs. Tighten all four hex
nuts evenly until the unit is snug against the mounting surface.
Flush Mounting the GPSMAP 4000/5000 Series Unit
 previous next