Garmin 7212 Marine GPS System User Manual


 
2 GPSMAP 6000/7000 Series Installation Instructions
Mounting the GPSMAP 6000/7000 Series Chartplotter
You can mount the GPSMAP 6000/7000 series chartplotters using one of two methods. You can use the included bracket to bail mount the
chartplotter, or you can use the included template and hardware to ush mount the chartplotter.
Mount the GPSMAP 6000/7000 series chartplotter in a location that provides a clear, glare-free view of the display and easy operation of the
controls or touch screen.
NOTE: You cannot bail mount the GPSMAP 7015/7215 chartplotters. Because of the larger size of these devices, you must ush mount a
GPSMAP 7015 or a GPSMAP 7215 chartplotter.
Bail Mounting the GPSMAP 6000/7000 Series Chartplotter
Use the included bracket to bail mount a GPSMAP 6008, 6208, 6012, 6212, 7012, or a GPSMAP 7212 chartplotter.
Tools required (not included):
Drill and drill bits
Pencil
Mounting hardware (screws or nuts, washers, and bolts)
NOTE: The bail-mounting hardware (screws or nuts, washers, and bolts) is not included. The holes on the bail mount are
5
/
16
in. (7.9 mm) in
diameter. Choose mounting hardware that ts the holes in the bail mount and securely attaches it to your specic mounting surface. The size of
the drill bit required depends on the mounting hardware you use.
To install the bail-mount bracket:
Note: You cannot bail mount the GPSMAP 7015/7215 chartplotters. Because of the larger size of these devices, you must ush mount a
GPSMAP 7015 or a GPSMAP 7215 chartplotter.
1. Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least 5 in. (12.7 cm) of clearance
behind the 6000/7000 series chartplotter for the wiring.
NOTE: To avoid interference, mount GPSMAP 6008/6208 chartplotters 15 in. (38.1 cm), GPSMAP 6012/6212 chartplotters 16 in. (40.6 cm),
and GPSMAP 7012/7212 chartplotters 25 in. (63.5 cm) from a magnetic compass.
2. Using an appropriately-sized drill bit, drill the pilot holes for your mounting hardware.
3. Secure the bail mount to the surface with screws and washers.
To install the GPSMAP 6000/7000 series chartplotter on the bail-mount bracket:
1. Loosely attach the mounting knobs to the GPSMAP 6000/7000 series chartplotter.
2. Slide the chartplotter onto the bail mount, and tighten the mounting knobs.
Bail-mount bracket
Mounting knob
Installing a GPSMAP 6000/7000 Series Chartplotter on the Bail-mount Bracket