Filter
Top Products
Changing Dipswitch Settings
12 309498H
Components Mounting Bracket
During system installation, double-faced tape can be
used to allow relocation of the Transceivers to optimize
RF communication.
Once RF communications are confirmed, the Trans-
ceiver can be permanently mounted on a desk top, wall,
or ceiling. If the component will be placed on a desktop
or horizontal flat surface, use the rubber feet that are
supplied. The feet are adhered to round indents on the
back side of the unit. If the component will be placed on
the wall or ceiling, use the Matrix mounting bracket (3)
and screws (4) to fasten the box to the mounting loca-
tion. See F
IG. 12.
1. Using the bracket as a template, mark the location
of the bracket holes on the mounting surface. Or see
Mounting Bracket Hole Dimensions, page 17.
2. Drill two holes.
3. Attach the bracket (3) to the wall or ceiling using two
1 in. sheet rock screws (4). Slide the transceiver
onto the bracket.
• If the Transceiver is mounted outdoors, it must
be placed into a protective water proof,
non-metallic outside housing meeting IP65
Standards for outdoor use.
•
Be sure to c
omply with all applicable local,
state, and national fire, electrical, and safety
regulations.
F
IG. 12
3
4