Filter
Top Products
15W034 Beacon Tower Kit Installation
2 313542D
15W034 Beacon Tower Kit
Installation
NOTE: Kit 15W034 is for ProMix 2KS manual systems.
1. Remove the 3/4 in. (19 mm) knockout on top of the
EasyKey. Feed the wires through the hole and
secure the beacon (1) with jam nuts (N) on the
inside and outside of the box. See F
IG. 1.
2. See F
IG. 4. Install the din rail (7) with two screws (8).
Install the header (5) on the din rail and connect the
cable (4) to J5 on the EasyKey display board.
3. Connect yellow and gray wires from beacon to the
power terminal. See F
IG. 2.
4. Connect orange, brown, and red wires to header (5)
pins 3, 4, and 5. See F
IG. 6 on page 6.
5. To enable the optional audible alarm, connect sky
blue wire to pin 3 on header (5). See F
IG. 6 on page
6. When enabled, it will sound for all system alarms.
6. When beacon wiring is completed, insulate the end
of each unused lead wire with insulation tape.
Beacon Signals
NOTE: See the ProMix 2KS operation manual for details
of the specific alarms.
F
IG. 1: Install Beacon on EasyKey
™
FIG. 2: Power Terminal Connections
1
TI14040a
N
INPUT AC
OUTPUT DC
DC
OK
+
-
-
N (-)
NC
NC
L (+)
TI14041a
Yellow (+24V)
Gray
(Common)
Flashing
Signal/
Audible Description
Amber A system warning is active; verify alarm.
Red A potlife alarm exists. System goes to
Standby.
Green Not used.
Audible A system warning is active; verify alarm.