Filter
Top Products
-4-
Model T10722/T10723 (Mfg. Since 01/13)
Mounting Safe
The safe has holes through the back and bottom
for mounting to a wall or floor.
When mounting to a wall, we recommend secur-
ing 1" wood stock to the wall studs, then securing
the safe to the wood. Make sure the mounting will
hold the weight of the safe and contents, as well
as the forces of opening and locking the door.
Batteries
The electronics of the safe are powered by four
AA batteries. If the fingerprint scanner or PIN pad
does not respond or if the red light on the security
pad stays ON when attempting a procedure, the
batteries need to be replaced.
Use the key to open the safe and replace the
batteries with four high-quality AA alkaline batter-
ies. Refer to Installing Batteries on Page 2 for
detailed instructions.
Note: When the batteries are removed, the record-
ed fingerprint scans and PIN number stay in non-
volatile memory and will remain functional when
the batteries are replaced.
Cleaning
Use a soft cloth moistened with warm water to
clean the painted surfaces of the safe. Do not use
solvents, abrasives, or spray cleaners that can
damage the finish or electronic components.
Always keep liquids away from the security pad
and the battery compartment to prevent damaging
the electronic components.
Regularly clean the fingerprint scanner lens with a
soft cloth moistened with warm water. Do not use
paper products that can scratch the lens. Do not
use chemicals or spray cleaners that can damage
the lens or electronic components.
Symptom Possible Cause Possible Solution
Security pad
does not properly
respond to input;
red light stays on.
1. Batteries are low or dead.
2. Electronic components are at fault.
1. Replace batteries.
2. Replace safe or use keys to operate.
Fingerprint scanner
will not record
fingerprint.
1. Scanner lens is dirty.
2. Fingerprint not readable.
3. Security pad memory has reached maximum
limit of 32 fingerprint scans.
1. Clean scanner lens.
2. Follow the Fingerprint Scanning Tips on Page 2.
3. Erase security pad memory by re-setting to factory
defaults.
Troubleshooting
Review the troubleshooting and procedures in this section if a problem develops with your safe. If you need
additional help with a procedure, call our Technical Support at (570) 546-9963.
Note: Grizzly cannot replace lost or stolen keys. Please contact your local locksmith if this happens.