Filter
Top Products
SKU 66967 For technical questions, please call 1-800-444-3353. Page 6
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
document including all text
under subheadings therein
before set up or use of this
product.
SET UP AND USE PRECAUTIONS
Set up only according to these in-1.
structions. Improper set up can cre-
ate hazards.
Wear ANSI-approved safety goggles 2.
and heavy-duty work gloves during
set up.
Keep area clean and well lit.3.
Do not set up when tired or when 4.
under the inuence of alcohol, drugs
or medication.
This product is not a toy. Do not al-5.
low children to play with or near this
item.
Use as intended only.6.
Inspect before every use; do not use 7.
if parts are loose or damaged.
Maintain product labels and name-8.
plates. These carry important safety
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
Caution: This inverter must only be con-
nected to batteries with a nominal
output voltage of 12 volts. Lower
voltage will not operate the inverter
properly, and more voltage could
damage the inverter or the device
being powered. If more than one 12
volt battery is to be used, the batter-
ies must be connected in a parallel
circuit; batteries connected in a series
circuit will produce too much voltage.
Place the Power Inverter on a at sur-1.
face. Make sure it has adequate ven-
tilation and is not in direct sunlight.
Locate the Inverter close enough to
the vehicle battery so that the Cables
can easily reach between the Inverter
and the vehicle battery. Position the
Inverter so that the Outlets are easily
and safely accessible.
To connect the Cable Ring Terminals 2.
to the (Positive) red and (Negative)
black Power Terminals on the back of
the Inverter:
Unthread the knobs covering the a.
Power Terminals.
Slide the red Cable’s Ring Termi-b.
nal over the post of the red Power
Terminal and the black Cable’s Ring
Terminal over the post of the black
Power Terminal.
Replace the knobs and tighten se-c.
curely.
Apply the parking brake of the vehicle 3.
connected to the battery. Place the
transmission in “Park” for an auto-
matic transmission, or in “Neutral”
for a manual transmission. Start the
engine.
Attach the red Cable’s Alligator Clip 4.
to the Positive (red) terminal on the
battery, then attach the black Cable’s
Alligator Clip to a clean unpainted
metal part of the chassis. (Note: If
connecting to a battery not installed
in a vehicle, connect to the Negative
(black) terminal.)
The red Fault LED will light up mo-5.
mentarily and the alarm will sound as
the Inverter draws power. Then the
alarm and red LED will turn off and