Humminbird 150 Fish Finder User Manual


 
Control Head Installation
Determine Where to Mount
Begin the installation by determining where to mount the control head.
Consider the following to determine the best location:
Tocheck the locationplanned for the control
head, test run the cables for the power and
transducer. See the installation section for
your transducer type in order to plan the
location of the transducer.
The mounting surface should be stable
enough to protect the control head from
excessive wave shock and vibration, and
should provide visibility while in operation.
Your PiranhaMAX™ may have one of two
differenttypesofmountingbases,eithera tilt
mounting base or a tilt and swivel mounting
base. The mounting area should allow
sufficient room for the unit to pivot freely, to
swivel if capable, and for easy removal and
installation (Figures 1 and 2).
Connect the Power Cable to the Boat
A 6' long power cable is included to supply power to the control head. You
mayshorten or lengthen the cable using18 gauge multi-stranded copperwire.
CAUTION: Some boats have 24 or 36 Volt electric systems, but the control head
MUST be connected toa 12 VDC power supply.
The control head power cable can beconnected to the electrical system of the
boat at two places: a fuse panel usually located near the console, or directly
to the battery.
NOTE: Makesure that thepower cable isnot connected tothe control headat the
beginning of this procedure.
Figure1
Figure2
2
Control HeadInstallation