Humminbird 3005 Marine GPS System User Manual


 
5. The unit comes on before I press POWER, and won’t turn off.
Check the transducer cable—if the outer jacket of the cable has been cut
and the cable is in contact with bare metal, you need to disconnect the
cable from the unit, then repair the cut with electrical tape. If there is no
problem with the cable, disconnect the transducer from the unit and see if
the problem is corrected, to isolate the source of the problem.
6. I get gaps in the reading at high speeds.
Your transducer needs to be adjusted. If the transducer is transom-
mounted, there are two adjustments available to you: height and running
angle. Make small adjustments and run the boat at high speeds to
determine the effect. It may take several tries to optimize high speed
operation. This can also be a result of air or turbulence in the transducer
location caused by rivets, ribs, etc.
7. My unit loses power at high speeds.
Your LEGEND 3000 SERIES has over-voltage protection that turns the unit off
when input voltage exceeds 20 VDC. Some outboard motors do not
regulate the power output of the engine’s alternator effectively and can
produce voltage in excess of 20 volts when running at high RPMs. The
L
EGEND 3000 SERIES
displays input voltage in the lower left corner of the
display when it exceeds 15 VDC. Use this readout to determine if the
voltage exceeds 20 VDC.
8. The screen begins to fade out. Images are not as sharp as
normal.
Check the input voltage. The L
EGEND 3000 SERIES
will display the current
voltage on-screen if it is greater than 16 or less than 10 VDC.The voltage
readout will appear in the bottom left corner of the screen.
9. The display shows many black dots at high speeds and high
sensitivity settings.
You are seeing noise or interference caused by one of several sources.
Noise can be caused by other electronic devices. Turn off any nearby
electronics and see if the problem goes away. Noise can also be caused
by the engine. If engine noise is causing the interference, the problem will
intensify at higher RPMs. Increase the engine speed with the boat
stationary to isolate this cause. Propeller cavitation can appear as noise
on-screen. If the transducer is mounted too close to the propeller, the
turbulence generated can interfere with the sonar signal. Ensure that the
transducer is mounted at least 15” (38cm) from the prop.
10. The screen does not display a full fish arch.
Check the running angle of the transducer. If the running angle is too
great, a full fish arch may not appear. Reduce the running angle of the
transducer. Several incremental adjustments may be necessary.
TECHSONIC INDUSTRIES, INC. ONE YEAR
LIMITED WARRANTY
We warrant the original retail purchaser that products made by Techsonic
Industries have been manufactured free from defects in materials and
workmanship. This warranty is effective for one year from the date of
original retail purchase. Techsonic Industries products found to be
defective and covered by this warranty will be replaced or repaired free of
charge at Techsonic Industries' option and returned to the customer
freight prepaid. Techsonic Industries' sole responsibility under this
warranty is limited to the repair or replacement of a product that has been
deemed defective by Techsonic Industries. Techsonic Industries is not
responsible for charges connected with the removal of such product or
reinstallation of replaced or repaired parts.
This warranty does not apply to a product that has been:
Improperly installed;
Used in an installation other than that recommended in the product
installation and operation instructions;
Damaged or has failed because of an accident or abnormal
operation;
Repaired or modified by entities other than Techsonic Industries.
Please retain your original receipt as a proof of the purchase date.This will
be required for in-warranty service.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES,
OBLIGATIONS OR LIABILITIES ON THE PART OF TECHSONIC INDUSTRIES AND
WILL BE THE CUSTOMER'S EXCLUSIVE REMEDY, EXCEPT FOR ANY
APPLICABLE IMPLIED WARRANTIES UNDER STATE LAW WHICH ARE HEREBY
LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL
PURCHASE. IN NO EVENT WILL TECHSONIC INDUSTRIES BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS
OR IMPLIED WARRANTY RELATING TO THE PRODUCTS.
Some states do not allow limitations on an implied warranty, or the
exclusion of incidental or consequential damages,so the above exclusions
may not apply to you. You may also have other rights, which vary from
state to state.
A separate Warranty is provided by international distributors for the
international models. This warranty is included by your local distributor
and this distributor maintains local service for your unit.
MAINTENANCE AND WARRANTY
TROUBLESHOOTING / WARRANTY / SERVICE POLICY
14