Filter
Top Products
Depth Offset
(Advanced)
Depth Offset will adjust the digital depth readout to indicate depth from the
waterline or boat's keel. Enter a positive vertical measurement from the transducer
to the waterline to read the depth from the waterline. Enter a negative vertical
measurement from the transducer to keel to read the depth from the keel. This
menu choice is available only when in Advanced User Mode (see Setup Menu Tab:
User Mode.)
To change the Depth Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Depth Offset on
the Setup menu.
2. Use theLEFT orRIGHT4-WAY Cursor Control keystochange theDepthOffset
setting. (-10.0 to +10.0 feet or -3 to 3 meters [International Models only],
Default = 0)
Temp Offset
(Advanced)
Temp Offset will adjust the temperature readout by the amount entered. This menu
choiceisavailableonlywheninAdvancedUserMode (seeSetupMenuTab:UserMode.)
To change the Temp Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Temp Offset on
the Setup menu.
2. Use the LEFT orRIGHT 4-WAYCursor Control keysto changethe TempOffset
setting. (-10.0 to +10.0 degrees, Default = 0)
50