Filter
Top Products
53
Noise Filter
(Advanced)
Noise Filter adjusts the sonar Noise Filter to limit interference on the display
from sources such as your boat engine, turbulence, or other sonar devices. The
Noise Filter menu choice is available when User Mode is set to Advanced (see
Setup Menu Tab: User Mode).
NOTE: The Off setting removes all filtering; Low, Medium and High1, High2, High3 settings
add progressive filtering of the sonar returns. High1, High2 and High3 are useful when there
is excessive trolling motor noise, but in some deep water situations, the High settings may
actually hinder your unit’s ability to find the bottom.
To change the Noise Filter setting:
1. Make sure you are in Advanced User Mode, then highlight Noise Filter
on the Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Noise
Filter setting. (Off, Low, Medium, High1, High2, High3, Default = Low)
Max Depth
(Advanced)
Max Depth adjusts the maximum depth of operation. The performance of your
Fishing System can be tuned to the maximum depth you will be fishing in by
setting the Max Depth. When a maximum depth is set, your Fishing System will
not attempt to acquire sonar data below that depth, thus increasing overall
performance. When Max Depth is set to Auto, the Fishing System will acquire
bottom readings as needed (within the capacity of the unit). If the bottom is
deeper than the Max Depth setting, the digital depth readout will flash, indicating
that the Fishing System cannot locate the bottom. The Max Depth menu choice is
available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
T
o change the Max Depth setting:
1. Make sure you are in Advanced User Mode, then highlight Max Depth
on the Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Max
Depth setting. (AUTO, 10 to 1500 feet, 3 to 500 meters [International
Models only], Default = AUTO)
531526-1_A - 747c_&_777c2_Man_Eng.qxp 10/2/2006 1:42 AM Page 58