Filter
Top Products
55
Sensitivity
Settings: Low = 1, High = 20; Default = 10
Sensitivity controls how much detail is shown on the display and will adjust
the sensitivity of all sonar frequencies.
When operating in very clear water or greater depths, increase the sensitivity
to see weaker returns that may be of interest. If the sensitivity is adjusted too
high, the display may become too cluttered.
Decrease the sensitivity to eliminate the clutter from the display that is
sometimes present in murky or muddy water. If Sensitivity is adjusted too low,
the display may not show many sonar returns that could be fish.
NOTE: The Sensitivity setting is a global setting and will adjust the sensitivity
of all sonar frequencies.
Upper Range
(Advanced: Sonar, Split Sonar, Circular Flasher,
and Big Digits Views only)
Settings: Various, see below.
Upper Range sets the shallowest depth range that will be displayed on the
Sonar, Split Sonar, Circular Flasher, and Big Digits Views. Upper Range is often
used with Lower Range.
NOTE: Aminimumdistanceof10 feetwill bemaintainedbetweentheUpper and
Lower Range regardless of the manual settings entered.
The available Upper Range settings are determined by your Humminbird® model
as follows:
• 778c HD: 0 to 1490 ft, 0 to 497 m (International Models only); Default = 0
• 778c HD XD: 0 to 3190 ft, 0 to 972 m (International Models only);
Default = 0
For example, if you areonly interestedin the area between 20 and50 feetdeep,
you should set the Upper Depth Rangeto 20 and the Lower Depth Range to 50.
The Sonar Viewwill thenshow the30 footarea between 20 and 50 andwill not
show the surface or the bottom (assuming the bottom is deeper than 50 feet).
Greater detail will be shown for the area between 20 and 50 feet.
Flasher X-Press™ Menu