Filter
Top Products
8
2
OPERATION
■ Receiving and transmitting
RECEIVING:
q Push [ ] to turn the power ON.
w Push []and []to select a channel.
e When receiving a call, adjust the audio output level to a
comfortable listening level.
TRANSMITTING:
r Take the microphone off hook.
• 2-tone, 5-tone mute may be released. (The ‘audible’ condition is
selected and “ ” appears.)
• A priority channel may be selected automatically.
t Wait for the channel to become clear.
• The channel is busy when “ ” appears.
y Push the [CALL] key when initiating a call from your side.
• Coded audio may be heard from the transceiver, then “ ”
appears.
• This operation may not be necessary depending on your signal-
ing system. Contact your dealer.
u While pushing and holding [PTT], speak into the micro-
phone at your normal voice level.
i Release [PTT] to receive.
IMPORTANT!: To maximize the readability of your signal;
➥ Pause briefly after pushing [PTT].
➥ Hold the microphone 2 to 5 cm (0.8 to 2 inches) from
your mouth, then speak into the microphone at a nor-
mal voice level.
DTransmitting notes
• Transmit inhibit function
The transceiver has several inhibit functions which restrict
transmission under the following conditions:
- The channel is in mute condition (‘Inaudible’ condition; “ ” does
not appear).
- Channel is busy.
- A matched/un-matched CTCSS code is received.
- The selected channel is a ‘receive only’ channel.
• Time-out timer
After continuous transmission for a pre-programmed period,
the time-out timer is activated causing the transceiver to stop
transmitting and automatically select receive.
• Penalty timer
Once the time-out timer is activated, transmission is further
inhibited for a period determined by the penalty timer.
IC-F110_F210_GEN.qxd 02.12.11 4:25 PM Page 8 (1,1)