Filter
Top Products
Page 2 of 2 65142X-XX (en)
PN 97999-6
PARTS LIST / 65142X-XX
Item Description
(size)
(Qty) Part No. [Mtl]
1
Cap
(651420-XX)
(1) 92990-1 [C]
(651422-XX)
(1) 92990-2 [SS]
2 Gasket (1) 91447 [D]
3 Spring (1) 90408 [SS]
4 Guide Button (1) 93949 [SS]
5
Ball
(13/16” o.d.) (651420-XX)
(1) Y16-126 [SH]
(651422-3T)
- - - - - - - - - - -
(651422-30, -40, -70, -100
(1) 90815 [SS]
6 Cartridge
(see table, page 1)
(1) - - - - - [SS]
7
Body
(651420-XX)
(1) 92992-1 [C]
(651422-XX)
(1) 92992-2 [SS]
8
Pipe Plug
(1/2 - 14 N.P.T.) (651420-XX)
(2) Y17-13-C [C]
(651422-XX)
(2) Y17-13-S [SS]
TYPICAL SYSTEM VIEW
Install the material lter either at the inlet of material handling
section or upstream from the other accessories (control handle,
etc.).
Refer to typical installation ( gure 2).
The lter unit was tested at the factory with a maximum work-
ing pressure of 6,000 p.s.i. (414 bar).
Two (8) pipe plugs are included with this unit to plug the inlet
and outlet ports not being used.
c
These system components are shown for installation purposes only
and must be purchased separately.
Filter
4-1/4" Pump
Material
Outlet Hose
Main air supply
F-R-L
Material
Inlet
Hose
Mounting
Bracket
Figure 2
1.
2.
3.
4
.
MATERIAL CODE
[C] = Carbon Steel
[D] = Acetal
[SH] = Hard Stainless Steel
[SS] = Stainless Steel
y
ARO® is a registered trademark of Ingersoll-Rand Company
y
y
Loctite® is a registered trademark of Henkel Loctite Corporation
y
y
572™ is a trademark of Henkel Loctite Corporation
y
5
6
7
1
2
3
4
Tighten to 30 - 40 ft lbs (40.7 - 54.2 Nm).
Apply Wet Sol “Plus” to threads at assembly.
Apply Loctite® 572™ to threads.
Figure 3
8
Figure 4