Filter
Top Products
Drop Arm Commode 2 Part No 1062011
Adjusting the Leg Height
NOTE: For this procedure, refer to FIGURE 1.
1. Remove commode from carton.
2. Align the snap button of each leg
extension with the appropriate
adjustment hole in the leg frame.
3. Make certain that the snap buttons are
fully engaged into the adjustment hole
of each leg frame and are at the same
height before using.
FIGURE 1 Adjusting the Leg Height
Installing/Removing the Commode Seat and Lid
NOTE: For this procedure, refer to FIGURE 2.
Installing
1. Align the seat clamps of the toilet seat onto the back frame rail.
NOTE: Each clamp should sit outside the pail holders.
2. Push down on seat until it clamps
firmly into place.
3. Repeat STEPS 1-2 to install the lid.
Removing
NOTE: Always remove the lid before removing
the seat.
1. Grasp the back corner of the lid and lift
up firmly.
2. Repeat STEP 1 for the seat.
FIGURE 2 Installing/Removing the
Commode Seat and Lid
Operating the Drop Arms
NOTE: For this procedure, refer to FIGURE 3 on page 3.
1. Grasp one arm latch handle firmly. Refer to Detail “A” of FIGURE 3.
2. Squeeze the arm latch handle toward the drop arm tube shown in FIGURE 3.
3. Gently lower the drop arm tube shown in Detail “B” of FIGURE 3.
4. Perform STEPS 1-3 for the opposite arm.
Snap Button
Leg Frame
Commode Seat
(Lid Not Shown)
Seat Clamp
Back Frame Rail
Pail
Pail
Holder