Filter
Top Products
7
&211(&7,1*72$5(*8/$7('32:(56833/<
To connect the transceiver to an appropriate regulated DC power supply, use an
optional PG-2W DC cable.
1 Confirm that the power of both the transceiver and the DC power supply is
OFF.
2 Connect the optional PG-2W DC cable to the DC power supply; the red lead to
the positive (+) terminal, and the black lead to the negative (–) terminal.
Fuses (3 A)
3 Connect the barrel plug on the DC cable to the DC IN jack of the transceiver.
• While a DC power supply is connected with the DC IN jack, the transceiver
automatically initiates charging the PB-45L battery pack.
Note:
X If the DC power supply voltage is below 12.0 V DC, you may not be able to charge the PB-45L
battery pack.
X The supply voltage must be between 12.0 V and 16.0 V to prevent damaging the transceiver.
If the input voltage exceeds approximately 17.5 V, the transceiver automatically turns OFF.
&211(&7,1*72$3&
The USB connector allows you to directly connect to a computer by using a
supplied USB cable.
• Download the virtual COM port driver from the URL listed below.
http://www.kenwood.com/i/products/info/amateur/software_download.html
PC (USB) port
<Baud rate: 9600 bps>
Supplied USB cable
PC
Depending on the usage condition of the USB apparatus, saved content may be lost. Kenwood
does not take responsibility for damages or lost content.