17
■ Priority Scan
A priority channel must be programmed in order for
Priority Scan to operate. A “P” appears on the
display when the priority channel is selected.
During Scan, the transceiver automatically reverts to
the priority channel when a signal is received on it,
even if a signal is being received on your current
channel.
Note:
◆
Your dealer programs the amount of time it takes for the
transceiver to check for a signal on the priority channel.
◆
If programmed by your dealer, you can temporarily add or delete
the priority channel from the scan sequence.
◆
Your dealer can program Scan to cancel the priority channel QT/
DQT tone (if a tone is set up on the channel) during Scan so that
all calls on the priority channel will be heard.