Filter
Top Products
30
• When set to notify you via both a tone and through
vibration (setting 3), the tone is emitted and the
transceiver vibrates when a busy signal is received and
the QT/ DQT signalling matches. As with a tone only, you
will not hear audio from the speaker until the tone is
stopped by pressing a key or the 15 second tone stops.
After the call is finished, the transceiver will wait for 10
seconds before resetting the Incoming Call Notification.
To select your Incoming Call Notification type:
1 Turn the transceiver power OFF.
2 Press and hold the MENU key while turning
the transceiver power ON (for 1 second).
3 Press the ▲ or ▼ key to select “
”.
4 Press the MENU key to select “ ”
(incoming call notification type off: no tone or
vibration), “
” (incoming call notification
type 1: you are notified by a tone), “
”
(incoming call notification type 2: you are
notified by vibration), or “
” (incoming call
notification type 3: you are notified by both a
tone and by vibration).
5 Press the PTT, MON, or CAL key to exit
Setting Mode.