Filter
Top Products
INSTALLATION
To install the handles onto the front panel of the repeater,
align the handles with the holes on the front panel, then
secure the handles using the supplied screws.
Please consult your dealer for installing the repeater and
antenna.
MICROPHONE
Connect an optional KMC-27A, KMC-27B, or KMC-9C
KENWOOD microphone to the MICROPHONE jack on
the front panel.
VHF FM REPEATER/ UHF FM REPEATER
TKR-740/ TKR-840
INSTRUCTION MANUAL
KENWOOD CORPORATION
© B62-1136-00 (K)
09 08 07 06 05 04 03 02 01 00
NOTICES TO THE USER
UNPACKING AND CHECKING EQUIPMENT
Note:
The following unpacking information is for use by your
KENWOOD
dealer, an authorized
KENWOOD
service facility, or the factory.
Carefully unpack the repeater. We recommend that you
identify the items listed in the following table before
discarding the packing material. If any items are missing
or have been damaged during shipment, file a claim with
the carrier immediately.
• If you detect an abnormal odor or smoke coming from the unit,
disconnect the power from the unit immediately. Contact your
KENWOOD service center or dealer.
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
◆
GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
◆
ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
◆
REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
metI rebmuNtraP ytitnauQ
ssalgtnorF4X-0952-01B1
)A4(esuF5X-7204-60F1
teswercsdnaseldnaH5X-1240-10K1
ylbmessaelbacrewoP5X-1170-73E1
)nip51(rotcennochtiweriwdaeL5X-8223-13E1
)nip21(gulperauqS5X-0140-95E1
wercsdesserD4X-3450-80N1
launamnoitcurtsnIXX-6311-26B1
THANK YOU!
We are grateful you purchased this KENWOOD repeater.
We believe this easy-to-program repeater will be highly
effective in your communications system, and will keep
personnel operating at peak efficiency.
KENWOOD incorporates the latest in advanced
technology into all of our products. As a result, we feel
strongly that you will be pleased with the quality and
features of this product.
FEATURES
•You can easily program channel data using the KPG-47D
version 2.00 or later (optional) on a PC.
•You can recall 1 of 32 preset channels using either a PF key or
the external control line.
• The firmware can be written to the Flash memory through an
external source.
• QT/DQT signalling can be programmed on each channel. It
simultaneously decodes up to 16 different QT/DQT tones.
• When using the KPG-47D version 2.00 or later (optional), RX
PLL lock voltage, RX input signal strength, TX PLL lock voltage,
TX output power, and the power supply voltage can be
monitored on a PC.
• The interface port can be used with external equipment, such
as a repeater controller.
• The repeater has multi-mode capability.
Wide: 30 kHz, 25 kHz/ Narrow: 15 kHz,12.5 kHz (TKR-740)
Wide: 25 kHz/ Narrow: 12.5 kHz (TKR-840)
•You can adjust the following functions from a PC:
• CW ID Deviation
• Digital Pager Balance
• Digital Pager Deviation
• DQT Deviation
• Maximum Deviation
• QT Deviation
• Remote TA
• Repeat Gain Level
• TX Power
• RX Audio Signal Output (RA)
• RX Detector Signal Output (RD)
• Signalling Balance
• Signalling Deviation (SD)
• Squelch (Analog/ RSSI)
•Test Tone Deviation
• TX Audio Input (TA)
•Voting Tone Level
PRECAUTIONS
• Do not expose the unit to rain or moisture; to prevent fire or
electric shock.
• Do not open the unit under any circumstances; to avoid risk of
electric shock.
• Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
• Do not place the unit in excessively dusty and/or humid areas,
nor on unstable surfaces.