Filter
Top Products
Comparison
3rd order Intercept Point characteristics
Intercept Point [dBm]
Interfering wave separation [kHz]
frx=14.2MHz,PRE AMP OFF,BW 500Hz,MODE CW,
-20.00
1 10 100
-10.00
0.00
10.00
20.00
30.00
40.00
50.00
TS-990S
Our old model
6
A key point in tapping maximum performance from the 1st mixer
in actual operation (say, CW operation) is to prevent the out ow of
unnecessary signals, other than the target signal, from the mixer to
the subsequent stage. This is because it can tap the maximum per-
formance of the digital IF lter using the DSP in the nal IF stage.
The TS-990S main receiver employs a 1st IF frequency 8.248 MHz
down-conversion format. It achieves superior close-in dynamic range
unattainable through conventional up-conversion formats. Even if
the interference is a close-in frequency, the receiver maintains a
relatively at dynamic range, which you can tune without losing your
target signal.
We have achieved a down-conversion format for all amateur bands
The horizontal axis shows separation of the target signal by interfering signal frequencies (two waves). At a frequency of 10 kHz,
interference 1 refers to reception frequency + 10 kHz, and interference 2 refers to reception frequency + 20 kHz.
The newly developed mixer contributes to achieving +40 dBm IP3
Main Receiver
Amateur band RF BPF Pre Selector feature Transformer feedback RF Amp
through
through through
0/6/12/18dB
270Hz
500Hz
6kHz
15kHz
2.7kHz
1st Mixer
Roofing
Filters
RF BPF
ATT
Pre Selector
Pre Amp Post Amp
Pre Selector 160m BAND
0.0 1.0 2.0 3.0 4.0 5.0
-100
-80
-60
-40
-20
0
Frequency(Hz)
Amplitude (dB)
The TS-990S has the overwhelmingly highest
quality receiver among the TS series.
The dual receivers facilitate reception on different bands.
The main receiver is the highest quality receiver among the TS-900 series,
thanks to its down-conversion con guration, newly developed mixer,
and ve types of roo ng lters. The highest quality transceiver shows its true
metal in contests, erce pile-ups and high-intensity signals.
The TS-990S will surely satisfy any real DX’er.
In place of the Double Balanced Mixer, which uses the J-FET, we have
installed the newly developed Double Balanced Grounded Switch Type
in the 1st mixer circuit, which is the heart of the main receiver.
The transceiver is also equipped with a pre selector function (works
on HF amateur band) that varies its tuning frequency in tandem with
the receiver frequency. It effectively dampens interference from strong
signals that cannot be minimized through bandpass lters on dedicated
amateur bands. Furthermore, we have achieved a +40dBm class of
third-order intercept point for the signal path of the 1st mixer, based on
select circuits and components, employing large core toroidal coils for
protecting against distortion from large input signals, as well as using
relays for the signal switching.