Filter
Top Products
22
Adjustable strap
Route the transducer cable
along the trolling motor
shaft. Use plastic ties (not
included) to secure the
cable to the shaft.
Flat washer
Lock nut
Bolt
Internal tooth washer
Plastic bracket
TMB-S Trolling Motor Bracket Installation
Note: The TMB-S bracket is designed for one-piece bracket transducers only.
The TMB-S trolling motor bracket (Part No. 51-45) is an optional accessory and is available
through LEI Extras at www.lei-extras.com.
The TMB-S bracket is used to attach a one-piece bracket transducer to a trolling motor. If you
regularly sh in water with a lot of underwater structure, such as rocks, stumps and trees, you
may consider using a Pod transducer for trolling motor installation. Pod transducers cannot be
“kicked up” by underwater structure.
Using the components supplied with the TMB-S bracket (adjustable strap, internal tooth
washer and plastic bracket) attach it to the transducer as shown in the diagram above.
Slide the adjustable strap through the plastic bracket as shown above, left, then slip the strap
around the trolling motor as shown in the image, at right. Position the transducer so its “face”
is pointing straight down when the trolling motor is in the water. Tighten the adjustable strap
securely to the trolling motor. Make sure there is enough slack in the transducer cable for the
trolling motor to turn freely.