Filter
Top Products
5
COM-1
LCX-15CI/
15CT
FROM GPS
RECEIVER
ORANGE (RECEIVE)
SHIELD (GROUND)
NMEA TRANSMIT
GROUND
The LCX-15CI/15CT can accept position information from any GPS
receiver that transmits NMEA 0183 data. Use the wiring diagram shown
above for NMEA input to the LCX-15CI/15CT.
See page 25 and 26 for NMEA and DGPS com port setup instructions.
Accessory Connections
The rear of this unit has three connectors: Power/Data, GPS, and Trans-
ducer. The power cable connects to the Power/Data connector, the cable
from the GPS module goes to the GPS connector, and the transducer
plugs into the Transducer connector.
Speed/Temperature Connections
This unit can use a speed sensor in addition to up to three temperature
sensors.
All transom-mount “Skimmer” transducers have a temperature sensor built
into them. To add another temperature sensor besides the one in the
transducer requires a MY-4X “Y” adapter cable and a TS-2X temperature
sensor. The transducer plugs into one end of the MY-4X, the TS-2X tem-
perature sensor plugs into another, and the last end plugs into the SO-
NAR port. The TS-2X temperature sensor has an extra connector for a
TS-3X temperature sensor. This lets you have three temperature sen-
sors, if desired.
Note: Do not combine the temperature sensors in any order other than
shown on the next page. For example, do not use two TS-3X temperature
sensors in place of one TS-2X and one TS-3X sensors. Each sensor is
programmed to work only on the channel it’s designed for.
PWR/DATA
LOWRANCE
GPS MODULE
TRANSDUCER