Filter
Top Products
20
storage compartment for the portable transducer. The PPP-12 can be used
with eight AA alkaline batteries.
To use a portable power pack, you simply install the batteries and then
attach the sonar unit to the power pack's bracket. Plug in the
power/transducer cable and you're ready to fish.
The PPP-12 has a quick-release mounting bracket built into the case.
Installing the Batteries
Release the latch on the front of the case. Open the case and install
eight AA batteries in the battery compartment. For the longest life, we
recommend you use alkaline batteries.
NOTE:
When the unit is not in use, we recommend you unplug the power
connector to reduce the possibility of corrosion or battery drain.
When you store the unit, always remove the batteries because dead
batteries can leak and corrode the contacts.
After installing the batteries, plug the sonar unit's power cable into the
battery compartment socket. Route the other end of the cable through
the opening under the mounting bracket and close the case.
Place the unit on the quick-release mount. The unit can be folded
down into the "Closed" position (as shown) for convenience in storing
or transportation, as well as for the protection of the unit.
Plug the cable into the unit, attach it to the bracket and turn it on. If it
doesn't work, make sure the battery terminals are making good contact
PPP-12 case
(shown closed)
Quick-release
mount
Sonar unit,
face down