Filter
Top Products
10
TRANSDUCER AIMED TOOTRANSDUCER AIMED TOO
TRANSDUCER AIMED TOOTRANSDUCER AIMED TOO
TRANSDUCER AIMED TOO
FAR FORWARDFAR FORWARD
FAR FORWARDFAR FORWARD
FAR FORWARD
hull. Place the transducer into the epoxy, twisting and turning it to force
any air bubbles out from under the transducer face. The face of the
transducer should be parallel with the hull, with a minimum amount of
epoxy between the hull and transducer. After the epoxy dries, route the
cable to the sonar unit.
Fish Arches
If you do not get good fish arches on your display, it could be the
transducer is not parallel with the ground when the boat is at rest in the
water, or at slow trolling speeds. If the arch slopes up, but not back
down, then the front of the transducer is too high and needs to be
lowered. If only the back half the the arch is printed, then the nose of the
transducer is angled too far down and needs to be raised.
TRANSDUCER AIMED TOO FARTRANSDUCER AIMED TOO FAR
TRANSDUCER AIMED TOO FARTRANSDUCER AIMED TOO FAR
TRANSDUCER AIMED TOO FAR
BACKBACK
BACKBACK
BACK
PROPER TRANSDUCER ANGLEPROPER TRANSDUCER ANGLE
PROPER TRANSDUCER ANGLEPROPER TRANSDUCER ANGLE
PROPER TRANSDUCER ANGLE