Filter
Top Products
Other Scanning Features
• Look Back: Any channel, when not in the scan mode, can be
programmed to "look back" at the "Priority" channel. This feature
is ideal for those who do not need scan as defined above, but want
to make sure that they never miss a call on the "Priority" channel if
another channel has been selected. Once a "look back" channel
has been selected, the radio will periodically "look back" at the
"Priority" channel. Ifactivity is detected on the "Priority" channel,
the radio will move to that channel for as long as it remains active.
• Scan Channel Delete: To temporarily delete a channel from the scan
list, simply press the monitor button while scanning and stop on
the channel to be deleted. This will remove that channel from the
scan list until the channel is changed or the radio's power is reset.
When power is restored or the scan list channel position is again
selected, the original Dealer programmed scan list will be activated.
• CTCSS/DCS Scanning: The SP-130/140 can be programmed by
your Dealer to scan for tone. This will help block out unwanted
calls.
• Normal Scan TX: Allows a transmission only after a call is received,
depending on the programmed scan delay time. After the scan
resumes, and a transmission is made, the radio will sound an
alarm (two beeps) and will not allow a transmission.
• Priority Scan TX: Allows a transmission after a call is received
depending on programmed scan delay time. The transmission will
be made on the channel that the call was received. After the scan
resumes, if a transmission is made, the radio will transmit on the
programmed priority channel.
• Priority Only TX: Allows a transmission on the priority channel
when scanning and not stopped on an active channel. It can also be
programmed to always transmit on the priority channel if scanning
or stopped on an active channel.
• Receive Only Scan: This allows only reception. If a transmission is
made at any time, the radio will sound an alarm (two beeps) and will
not allow the transmission.
12