Filter
Top Products
H. UP (? ) button
• Press to select the next available mode
• Increase the parameters
• In time with seconds display mode, press and hold for 2
seconds to activate/ deactivate radio controlled time signal
search manually.
• In time with weekday display mode, press and hold for 2
seconds to switch time zone from Pacific, Mountain, Central to
Eastern.
I. MEM/ HISTORY button
• When temperature mode has been selected, press to recall the
minimum or maximum temperature and humidity readings of
main and remote units.
• Press and hold for 2 seconds, collected memories will be
cleared.
• When pressure mode has been selected, press once to check the
historical pressure data for the past 24 hours.
J. WALL- MOUNT hole
• A recessed opening to mount the unit on a wall
K. BATTERY COMPARTMENT
• Requires two (2) UM-3 or AA 1.5V alkaline batteries
L. TABLE STAND
BATTERY INSTALLATION
• Remove the battery door located at the back of the main unit.
• Insert two (2) AA size batteries according to the polarities
shown and replace the battery compartment door.
• When placing the main unit on the table or other horizontal
surface, unfold and adjust the table stand for the desired
viewing angle.
PLACEMENT
• Make sure that the main unit is locating within the operating
range of all remote sensors.
• Ideally the main unit should be placed within line of sight of
remote sensors. Avoid placing the main unit where surfaces
emitting and radiating heat (e.g. heating ducts or air
conditioners) and areas with interference from wireless devices
(e.g. cordless phones, radio headsets, baby monitoring devices
and other electronics).
9