Filter
Top Products
OPERATION
23
Inflating
!
CAUTION
Do not use a compressed air source to fill air chambers. Over
inflation may result in damaged seams and/or bulkheads.
IMPORTANT: Do not inflate or deflate one air chamber at a time.
When inflating or deflating, maintain a balanced air pressure
between air chambers to prevent stress or potential damage to the
inside diaphragm that separate the air chambers.
b
a
c
14778
d
a - Valve stem
b - Closed position
c - Open position
d - Valve cap
NOTE: Air pressure can be measured using the air gauge provided
with the air pump or using an accessory air pressure gauge.
1. Inflate the two air chambers as follows:
NOTE: Install the removable seat before the boat is fully inflated.
Hook the flanges that are located on the bottom of the seat into
the nylon straps on the side air chambers.
a.Clear a flat surface that is clean and free of sharp objects.
b.Unfold the boat and spread it out flat.
c. Unscrew the valve caps by turning a quarter of a turn
counterclockwise. Make sure the valve stems are in the
closed position. Push in on the valve stem and rotate to the
closed position.
d.Attach the air hose adapter to the air valve.