Filter
Top Products
Model 1001LWX Owner’s Manual
Page 5 www.midlandradio.com
Power Wiring (negative ground only):
Power Wiring (negative ground only):
Step 1: If you have not determined whether your vehicle has a negative or positive
ground, do so now. Then disconnect the negative lead from the battery to prevent
short circuits that can occur during wiring. Do not connect this transceiver to posi-
tive ground electrical systems.
Step 2: With negative ground
A. Connect the positive (RED WIRE) the one with in-line fuse holder to either the
(a) fuse block, (b) cigarette lighter, or (c) directly to the positive post on your
battery. Usually, the fuse block is the most convenient connecting point. It is
also possible to connect to the Accessory terminal on the fuse block or ignition
switch, so that your CB automatically goes off when the ignition goes off.
B. Tightly connect the ground (BLACK WIRE) directly to the vehicle’s metal frame.
A good direct metal-to-metal ground is essential for optimum performance.
Installations using the cigarette lighter socket for power require an extra ground
wire from the radio chassis to the vehicle if the radio is not fastened to a grounded
part of the vehicle.
Installation of Microphone Hanger:
Installation of Microphone Hanger:
Mounting holes are provided on the microphone hanger bracket. The bracket can be
attached to the vehicle dash, the holes provided on the left side of the radio, or other con-
venient location.
Antenna:
Antenna:
How to select, position, install and tune the right antenna for you:
You can choose from two types of mobile CB antennas: full-length whip and loaded whip -
and a variety of mounts (depending on where you locate your antenna). The dealer who
sold you your Midland CB can advise which type is best for you.
*Where you locate your antenna does make a difference.*
S
ome general rules for antenna location that can aid CB performance:
1. Put your mount as high on the vehicle as possible.
The higher the proportion of antenna length that is above the roof, the better.
2. If possible, mount the antenna in the center of whatever surface you choose.
3. Keep antenna cables away from noise sources, such as the ignition system, gauges, etc.
4. Make sure you have a solid metal-to-metal ground.
5. Exercise care to prevent cable damage.
Essentially, you have five location choices: the roof, gutter, rear deck, front cowl or rear
bumper. Where you decide to locate your antenna will determine the type of antenna you
install. Consult your Midland CB dealer for advice and guidance, and measure your needs
against the attributes of the various Midland antenna models they carry.