Filter
Top Products
8-9
Care and Maintenance
5. Close the ball valve of step 2 unless the boat is on a trailer or
lifted up in the air, in which case it should be left open.
6. Run the engine for several minutes after it has reached the
normal operating temperature to ensure proper flushing.
7. Reduce the engine speed to idle, shut off the engine and
immediately shut off the water supply hose. Please note, failure
to shut off the water supply hose immediately could possibly
result in engine damage.
8. If the ball valve of step 5 was closed, open it now and close the
step 1 ball valve.
9. Remove the water supply hose and reinstall the deck fitting cap
securely.
Battery Maintenance
Take care when connecting or disconnecting a battery charger. Be
sure the charger is turned OFF and unplugged from power source
when you clip ON/OFF the connecting clamps.
Make sure you have a solid connection with the charging clamps.
Poor connections are common causes of electrical arcs and engine
problems. Follow instructions.
Explosion or fire hazard from vented
fumes can cause death or serious injury.
• Wear eye protection and rubber gloves when working
on or around batteries.
• DO NOT charge or use a battery booster to start your
engine.
• Charge the battery outside of the boat.
• DO NOT smoke or bring a flame near a battery at any
time.
• DO NOT have your head directly above a battery when
making or breaking electrical connections.
• DO NOT use a metal object to spark between battery
posts to check if the battery is charged.
!
V-Drive Sec 8_2010.qxp:Naut Air Sec 8.qxd 7/22/09 1:47 PM Page 8-9