Filter
Top Products
4-16
Section 4
Changing the Primary User Code
NOTICE
The current primary code must be used to change to another
primary code.
Make sure the system indicator light is off.
1. Enter the Primary User Code, then press and release the 1/2
key and the 7/8 key at the same time to put the system in the
code programming mode. The system indicator light will flash.
2. Enter a code from two to eight characters and press START. For
verification, reenter the code and press START again. The
system indicator light should stop flashing and stay on. If the
light does not stop flashing, press STOP and begin again.
To lock the system, reenter either the new Primary User Code or
the Master Embedded Code and press STOP.
NOTICE
Changing the Primary User Code will erase the Secondary User
Code.
Programming or Changing the Secondary User Code
NOTICE
The Secondary User Code will only lock or unlock the system and
cannot be used for any reprogramming
Make sure the system indicator light is off.
1. Enter the Primary User Code and press and release the 1/2 key
and the 5/6 key at the same time to put the system in Code
Programming Mode. The system indicator light will flash.
2. Enter a code from two to eight characters and press START. For
verification, reenter the code and press START again. The
system indicator light should stop flashing and stay on. If the
light does not stop flashing, press STOP and begin again.
To lock the system, reenter any of the three codes and press STOP.
216V Sec 4_2009.qxd:Naut Air Sec 4.qxd 1/21/09 9:21 AM Page 16