Filter
Top Products
| 06
REPLACEMENT PARTS
Replacement parts are available by calling Ocean Kayak customer service
at 800-8-KAYAKS.
Motor fails to turn on or loses power after a short running time:
• Make sure the kill switch tether is in place.
• Check circuit breaker. The reset lever will be angled out at a
60 degree angle if blown. Reset by pressing the lever back in.
• Insure that the motor plug is fully inserted in the receptacle in
the transom of the boat and that both are free of any corrosion.
• Check battery connections for proper polarity and make sure
battery terminals are clean and corrosion free. Use fine sandpaper
or emery cloth to clean terminals.
• Check battery charge, if low return to full charge.
• With battery disconnected make sure prop turns freely. Also
check behind prop for obstructions and debris. See prop
replacement instructions on page 5.
• Check that speed control knob is securely attached to pivot post.
• If this still doesn’t solve the issue, contact customer service.
Motor stops working completely after a short time:
• Turn the speed control dial to the “off” position. Then continue
normal operation.
• Insure that the motor plug is fully inserted in the receptacle and
that both are free of any corrosion.
• Check battery charge, if low return to full charge.
• Insure that the kill switch tether is in place.
You experience prop vibration or loud vibration noise coming
from the motor during normal operation:
• Tighten motor tie down strap to reduce vibration.
• Remove and rotate the prop 180 degrees. See propeller
replacement instructions on page 5.
• If prop is damaged replace with the MKP- prop kit (see page 5).
For all other techincal questions and concerns, contact
Ocean Kayak customer service at 800-8-KAYAKS or
service@oceankayak.com.
TROUBLESHOOTING
| 07
FREQUENTLY ASKED QUESTIONS
I pulled my kill switch and my battery died overnight,
what happened?
The kill switch is not designed as an on/off switch but as an emergency kill
switch. It is recommended to disconnect the battery for any prolonged
storage to eliminate battery drainage.
My motor does not go directly into reverse from full speed.
Is it broken?
The motor control unit requires being reset before switching from forward to
reverse or reverse to forward. This process is simply setting the dial control to
the off position for approximately 2-3 seconds.
Can I install an after market prop on my motor to increase speed?
This is not recommended as it will increase the amp draw of the motor causing
it to overheat. The use of any non-standard parts will void the warranty.
How important is the battery selection for the electric motor usage?
The battery is a critical element of your electric motor system. A high-quality
deep cycle marine battery should always be used. Unlike automobile
batteries, deep cycle marine batteries are designed to be drawn down to a
discharged state and then recharged. (To extend the life of your battery, always
recharge after use. Most deep cycle marine batteries fail due to lack of proper
maintenance.)
What size battery do I need?
We recommend using a sealed 12 volt group 24 deep cycle battery with a mini-
mum 85 amp hour rating. A group 24 is the largest size battery that can be used
with the Torque kayak.
The batteries I have seen do not have an amp hour rating, they list a
reserve capacity. How do I choose the right battery?
If an amp hour rating is not available, select a deep cycle marine battery with a
minimum of 140 minute reserve capacity.
What do I need to recharge the battery?
We recommend using a multi-stage charger such as the Minn Kota MK110P.
How long will it take to recharge the battery?
The amount of time it takes to recharge the battery will depend on the type of
charger being used. A charger with a higher amp output will charge quicker.
How long will my kayak run on a fully charged battery?
The amount of run-time will vary depending on the amp hour rating of the deep
cycle battery being used. The higher the amp hour rating the more run-time you
will have. As a general estimate, the Torque 12 volt motor will pull 25 amps
at full speed.