Filter
Top Products
2.3 To disengage Hold press and hold the “MODE” key until the reading
starts flashing. Release the “MODE” key then press the “MODE” key
once more, the display will read “HOLD”. Press the “ENTR” key, the
display will read “NO H” Press the “ENTR” key once more and the
display will return to reading the system pressure.
3.0 To Set Alarms
3.1 Press and hold the “MODE” key until the reading starts flashing, then
Press the “MODE” key twice more. The display will read “AL 1”. Press
the “ENTR” key to display the alarm setting. Pressing the “ENTR” key
again will set the alarm and return the display to the normal mode. If the
alarm setting is to be changed, the “up” and “down” keys can be used to
increase or decrease the setting one count at a time, Pressing the “MODE”
key and holding it down while Pressing “up” or “down” momentarily will
change 10 counts for each key operation. If the “MODE” key and “up” or
“down” are held down simultaneously, the setting will ‘FREE RUN’ until
the key is released.
NOTE: While setting the alarm, only one segment of the analog scale is
displayed and it corresponds to the % full scale of the alarm setting.
3.2 When the desired alarm setting is displayed, Press “ENTR” to set and
return to normal mode.
3.3 To set alarm 2: Press and hold the “MODE” key until the reading starts
flashing, then Press the “MODE” key three more times. The display will
read “AL 2”. Press “ENTR” key to display the alarm setting. Pressing
the “ENTR” key again will set the alarm and return the display to the
normal mode. If the alarm setting is to be changed, the “up” and “down”
keys can be used to increase or decrease the setting one count at a time,
Pressing the “MODE” key and holding it down while Pressing “up” or
“down” momentarily will change 10 counts for each key operation. If
the “MODE” key and “up” or “down” are held down simultaneously, the
setting will ‘FREE RUN’ until the key is released.
NOTE: While setting the alarm, only one segment of the analog scale is
displayed and it corresponds to the % full scale of the alarm setting.
3.4 When the desired alarm setting is displayed, Press “ENTR” to set and
return to normal mode.
M3367/0606 DPG10L
5