Filter
Top Products
10
OPERATION
1. Turn
VOL
clockwise to turn on the
transceiver.
2. Select Channel A or B using the
CHANNEL
switch on the top of the
transceiver.
3. To conserve battery power, set
POWER
to
LO
. If the person you
transmit to has trouble receiving
your signal, set
POWER
to
HI
.
4. To transmit, hold down push-to-talk,
then hold your transceiver about 3
inches from your mouth and speak
slowly in a normal tone of voice. The
BUSY•TX/LO BATT indicator lights
red.
5. When you finish your message,
release push-to-talk. The BUSY•TX/
LO BATT indicator lights green
when you receive a transmission.
6. Adjust
VOL
to a comfortable listen-
ing level.
7. If you are not using CTCSS, wait
until there is no signal on the chan-
nel, then slowly turn
SQL/CTCSS
clockwise until the background
noise stops.
Note:
Do not turn
SQL/CTCSS
too
far clockwise because you might cut
out weak signals.
If you are using CTCSS (see “Why
Use CTCSS?” on Page 11), turn
SQL/CTCSS
counterclockwise until it
clicks.
8. To turn off the transceiver, turn
VOL
counterclockwise.
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
19-1205.fm Page 10 Tuesday, August 3, 1999 10:30 AM