Filter
Top Products
14
EN
Radio
Selecting Tuner Band
1. Press SOURCE to enter Tuner mode.
2. Press BAND to select between FM or AM Radio
band.
Tuning to a Station
Press or to select frequencies. Press
and hold or to scan frequecies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
• Press TUNE MODE to toggle TUNE and
PRESET mode.
• Press or to access the previous or
next preset station.
Auto Preset Programming
(FM only)
Press and hold the BAND button for 2 seconds to
scan stations in FM band. The stations will then
be stored as preset channels. A maximum of 32
stations can be stored. Beware of your preset
channels being erased accidentally because the
scanning and storing process is automatic upon
pressing the button. You can stop the automatic
scan by pressing any button, but the erased
stations cannot be recovered.
Manually Setting Presets
1. Press TUNE MODE to enter TUNE mode.
2. Press or to access the desired
frequency.
3. Press the PROG button once and the most
recently accessed program location flashes on
the display.
4. If a different program location is preferred,
press or to move to the desired
preset number (1-32).
5. Press PROG to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and
stereo mode. (Remote Only) “STEREO” is
displayed in stereo mode.
Tips:
Your audio system has 32 preset stations.
Preset 01
87.50MHz
Auto Prog
87.50MHz
Preset 2
90.50MHz
Tips:
Under PRESET mode, press or
can only access the preset stations. Manually
tuning is not accessible in this mode.
RS2058 EN_Sirius 8/5/06 10:55 AM Page 21