Sceptre Technologies E27 Marine Instruments User Manual


 
SCEPTRE E27 Page15
If You have VGA Connection on Your Video Card…
1. Make sure the power of E27 LED MONITOR is turned off.
2. If you were previously using a CRT (bulky) monitor, please hook up your old
monitor first and make sure your refresh rate is set to 60 Hz frequency before using the
E27 LED MONITOR. You can find the refresh rate information and change it by RIGHT
CLICKING on the desktop with nothing selected. After you have right clicked, select the
PROPERTIES option. Click on the SETTINGS tab. Click on the ADVANCED button.
Click on the MONITOR tab. In that tab, change the refresh rate to 60 Hz and click on
APPLY. After the refresh rate changed, please shut down the computer and monitor.
3. Obtain the VGA cable and connect to the VGA connection on your PC. Connect the
other end of the cable to your E27 LED MONITOR.
4. Turn on the power of both the E27 LED MONITOR and the PC.
Please Note:
The PC’s clearest picture is ran with 1920 x1080 at 60 Hz.