Filter
Top Products
11
VIII. Care and maintenance (After your dive)
1) After each dive, soak the sealed light in fresh water for about
15 minutes to remove any residual salt, sand and dirt. Never
allow the saltwater to dry on the light.
2) Push the power button about 10 times to clean any saltwater
or sand trapped under the button.
3) Let the water drain out of the small holes located at the bottom
of flex arm. (If using Flex Arms - see page 14 for optional
accessories).
4) Dry off the light with a towel. Make sure you and the light are
dry before opening the waterproof battery cap.
5) Remove battery before storing the light.
6) Allow light to thoroughly dry before storage.
7) Never use any detergents, cleaners, solvents or chemicals to
clean the light.
8) Insert a fresh Moisture-Muncher capsule (item #SL911) inside
the battery compartment during storage to help keep the inside
dry and free of corrosion or mildew during storage.