Filter
Top Products
General
The transponder SZT 1011 is a mains-powered light-impulse amplifier
designed to increase the effective range of the infrared transmitter
SKI1 011. It is used in those cases where the radiated power of the
SKI1 011 is not sufficient for illuminating larger rooms with infrared light.
The transponder works as an infrared receiving and transmitting station:
The infrared signal emitted by the SKI1 011 is picked up by an array of
receiving diodes, amplified and immediately transmitted further. The
SZT 1011 is able to illuminate rooms with a floar area of up to 80 -m2.For
larger rooms acorrespondingly larger number oftransponders is required.
The transponder is fitted with a squelch to prevent transmission from
being disturbed by hissing noise. The On/Off indicatar isared LED which
lights up whenever the transmitter is turned oll or the squelch has
switched. The transponder can be mounted either on walls or on floor
stands litted with a !s"-thread (see lig.).
Location and mounting 0' the transponder
The ideal conditions for optimal illumination of agiven room are asfolIows:
1. The maximum ceilin~ height must not exceed 3.5 m.
~
2. The ceiling itself must form aflat, level surface. J
3. The walls may not be covered or hung with light-absorbing material or
objects.
The transponder should, if possible, be set up on the window side of the
room in order to prevent a large proportion of the light power from
escaping outside. The emission of the infrared light from the transponder
should not be obstructed by curtains or other objects.
Example
8
11111
Operation with 1transponder
Operation with two transponders
Depending on whatever happens to be better, the transponder can be
mounted either on to a floar stand fitted with a %"-thread or on a wall in
the vicinity of a mains socket.
4
Operation
After inserting the plug into the mains socket, the transponder is now
ready to function. The unit can only be switched off by removing the plug
from the mains. However, this is only necessary ifthe transponder is to
remain idle for aIonger period oftime (e. g. during school holidays). When
plugged-in, the transponder isput into operation whenever the transmitter
is switched on. Switching the transmitter off, however, automatically puts
the transponder on "Stand-by".
In the "Stand-by" condition, the transponder uses only approx. 3.5 VA.
Please note
The transponder can be powered from either 220 V or 110 V mains
circuits. On leaving the factory it is ready for 220 V-operation. Forthe
conversion to 110V-operation it isnecessary to remove the plug from the
mains and to change certain internal solder bridges.
}
I
p
~
Radiatedpower
SZT 1011
> 2500 mW
(impulselightpower)
35
, max.80 m2
8
,220V/110V + 20%
-15%
changeot internal solderbridge)
"Stand-By": approx,3,5VA.
Operation:max,approx, 10VA
.80 kHz:t 10%
.'1 ~s:t 10%
Numberottransmittingdiodes
Sizeotroomilluminated ..
Numberot receivingdiodes
Supplyvoltage
Powerconsumption
Max.pulserepetitiontrequency
Transmissionimpulsewidth
Dimensionsin mmincluding
coverstortransmittingandreceivingdiodes
Weight
Colour
140x 100x 53
approx. 10009
. black
5
------