Filter
Top Products
HX460S
How to use the Quick Draw Belt Clip
1. Connect the hanger to the rear of the HX460S, using the supplied
screw (Figure 4-a).
Use only the screw included
with the clip to mount the clip
to the back of the transceiver!
2. Clip the Quick Draw Belt Clip to
your belt (Figure 4-b).
3. To install the HX460S into the
Quick Draw Belt Clip, align the
hanger with the Quick Draw Belt
Clip and slide the HX460S into
its slot until a click is heard.
4. To remove the HX460S from the
Quick Draw Belt Clip, Rotate the
HX460S 180 degrees, then slide
the transceiver out from the Quick
Draw Belt Clip (Figure 4-c).
Page 9
4. OPERATION
4.1 INITIAL SETUP
NOTE
Never key the transceiver without an antenna connected, as this may
cause damage to the transceiver. Do not operate the transceiver while
charging its battery.
1. Install the belt clip on the transceiver, if desired.
2. Install the nylon carrying strap on the the trans-
ceiver, if desired.
3. Install the battery pack on the transceiver (see
figure 6 and section 5.2).
4. Install the antenna onto the transceiver.
NOTE
Water resistance of the transceiver is assured
only when the battery pack and antenna are
attached to the transceiver. Figure 3
Antenna Installation
Figure 4
(a)
(b)
(c)
belt