Filter
Top Products
SUPRA - 28
© 2005 Skier’s Choice, Inc.
Depth Sounder
Setting Units
The depth sounder can display depth in either standard or
metric units.
Perform the following steps to change the display units:
1.Simultaneously press the up and down buttons.
Either the FT or M units indicator display text will flash.
THEN...
2.To set feet units, press the up button.
The FT indicator display text will flash for five seconds
and return to normal mode display with feet as the current
units.
OR...
3.To set Meter units, press the down button.
The M indicator display text will flash for five seconds
and return to normal mode display with Meters as the
current units.
NOTE: When power is applied or removed and
reapplied, the units display defaults to feet units.
Setting Deep Alarm
The deep alarm function can be set for depths ranging from
3 feet (1.0 Meter) to 200 feet (60.9 Meters). An alarm triggers
when the water depth is greater than the set value.
Setting Deep Alarm (continued)
To set the Deep Alarm, perform the following:
1.Press the down button. The current deep alarm depth
setting will display.
2.Press the up or down button to increase or decrease
respectively the deep alarm depth value.
Pressing either button once will change the depth value
in 1-foot or 0.1 Meter increments. Holding either button
will change the depth value in 9-foot or 1-Meter
increments per second.
3.After setting the depth value, the alarm and down arrow
icons will blink for five seconds then the display will return
to normal operating mode with the alarm and down arrow
icons displayed.
When triggered, an audible alarm sounds for ten seconds
while flashing the warning LED, alarm and down icons on
the display. After ten seconds, the audible alarm mutes but
the LED and display icons continue to flash.
NOTE: When power is removed from the instrument, all depth
settings are returned to “000”.
Setting Shallow Alarm
The shallow alarm function can be set for depths ranging
from 3 feet (1.0 Meter) to 200 feet (60.9 Meters). An alarm
triggers when the water depth is less than the set value.
To set the Shallow alarm, perform the following:
1.Press the up button. The current shallow alarm depth
setting will display.
2.Press the up or down button to increase or decrease
respectively the shallow alarm depth value.
Pressing either button once will change the depth value
in 1-foot or 0.1 Meter increments. Holding either button
will change the depth value in 9-foot or 1-Meter
increments per second.
3.After setting the depth value, the alarm and up
arrow icons will blink for five seconds then the display
will return to normal operating mode with the alarm and
up arrow icons displayed.
When triggered, an audible alarm sounds for ten seconds
while flashing the warning LED, alarm and up icons on the
display. After ten seconds, the audible alarm mutes but the
LED and display icons continue to flash.
NOTE: When power is removed from the instrument, all depth
settings are returned to “000”.