Filter
Top Products
www.tanakapowerequipment.com 5 custsvc@tanaka-ism.com
Owner’s Manual
TOB-120,TOB-300
Preparation for Operation
WARNING: Failure to follow all instructions could result in personal injury and/or damage to unit. Remove
wire from spark plug before attempting any adjustment or assembly procedures.
Instructions contained in this manual apply to several models. Use the instructions that apply to your unit.
Fuel Mixture
IMPORTANT: 2-cycle engines require that oil be mixed with fuel. Refer to Fuel in Operation section of this
manual for recommended mixture.
Handle Assembly
Model 120
Place handle (throttle lever up) into position on joint pipe holder with
notch on end of handle against handle stopper. Secure to joint pipe
holder with wing head bolt, lock washer, two plain washers, and Hair
Pin. Attach throttle cable to carburetor bracket.
Model 300
Place handle (throttle cable down) into position on clutch case. Be sure
flat of handle is set in notch of handle stopper. Secure to clutch case
with 8 x 30 bolt, lock washer, and two plain washers. Attach throttle
cable to carburetor.
Gear Housing
Check gear housing for proper level of grease prior to operation. See Lubrication and Maintenance section for
proper procedures.