Filter
Top Products
Operation
Teledyne Analytical Instruments 28
4.2.4 Fuel
1. Open the main valve on the tank and set the fuel tank
pressure regulator to 30 psig.
3. Adjust the Fuel regulator until its pressure gauge reads the
recommended pressure of 3.5 psig.
Note: Adjust fuel settings only when the red LED (flame failure
light) is off.
TELEDYNE ANALYTICAL INSTRUMENTS
BYPASS FLOW
SPAN GAS
TEMP. GAUGE
SAMPLESPAN
Figure 4-1: Front Panel View of Regulator and Gages
4.3 Flame Ignition
Observe that after warm up count down timer reaches zero (timer to
preheat the sensor), the amber heater lamp is blinking (indicating that