Filter
Top Products
BATTERY INFORMATION
General
Improper battery selection, use, installation and care are the cause of numerous
wireless system failures.
Alkaline Batteries: Alkaline batteries such as Mallory’s DURACELL or
Eveready’s ENERGIZER provide the most reliable operation in wireless transceiv-
ers. The use of low cost carbon-zinc batteries is NOT recommended.
Nickel-Cadmium Batteries: These batteries can save you money in the long run,
as they can be recharged, but they can also cause disappointing wireless perfor-
mance. If you want to use rechargeable nickel-cadmium batteries you must select a
heavy duty nickel-cadmium (NEDA 10015 or equivalent)
BC-4 Battery Charger
Figure 13
BC-4 Battery Charger
Remove the battery holder from the TR-200.
Snap the terminal connector onto the battery holder
and plug the charger into a 110 Volt outlet.
Full charge of the battery pack is obtained after 14 to
16 hours. A full charge will last 8 to 10 hours. Exten-
sive over-charging may damage or destroy the batter-
ies. Please assure the charging time does not exceed
16 hours.
-13-
CAUTION
DO NOT ATTEMPT
TO CHARGE ANY
ALKALINE BAT-
TERIES WITH THIS
CHARGER. THIS
CHARGER IS TO
BE USED WITH
NICKEL CADMIUM
BATTERIES USED
IN THE TR200 BAT-
TERY HOLDER
ONLY.