Filter
Top Products
17
UNIDEN UH076DLX Handheld UHF-CB Transceiver
Operation
To Operate UH076DLX in Duplex Mode
Only channels 01 - 08 and 41 - 48 are available for Duplex.
Eg. CH01 is being used in your area for repeater use.
Press
dup
momentarily. The DUP icon appears.
Press
dup
again to deactivate the duplex operation.
UH076DLX will return to simplex operation.
NOTE
Check with your local retailer for available repeaters.
Scanning
The UH076DLX has two types of scanning; Open Scanning (OS)
and Group Scanning (GS). Scanning allows you to search for active
channels programmed in the OS or GS memory.
To initiate scanning;
Press
scan
and scanning starts. SCAN icon ashes during scanning.
Open Scan (OS) Mode
The absence of GS icon indicates that the unit is in OS mode. Allows
continuous scanning of channels stored in the Open Scan (OS) memory.
If an active channel is found, scanning will stop on that channel.
NOTE
The factory has preprogrammed all the UHF-CB channels
into the Open Scan channel memory. However, you can
change or customize the channels by following the steps on
programming Scan Channels on page 18.
Example: CH80 becomes active
If the received signal cease, the unit will wait for at least 3 seconds for
the signal to return, otherwise scanning resumes.
To skip the active channel, press
mem
momentarily. Scanning resumes.
To deactivate SCAN, press
scan
or
PTT
.