Filter
Top Products
OPERATION SUMMARY
• In the event of automatic shut down, turn the inverter
OFF (O) immediately. Do not restart the inverter until the
source of the problem has been identified and corrected.
• To avoid battery drain, always disconnect the inverter
when the vehicle is not in use for long periods.
• Do not expose the inverter to moisture.
• A
void placing the inverter near sources of heat or in
direct sunlight.
• When in use, make certain that the inverter is properly
ventilated.
• Do not use the inverter near flammable materials,
fumes, or gases.
• Always operate the inverter in accordance with the
instructions in this manual. Failure to do so may result
in property damage, personal injury, or loss of life.
• While connecting the inverter to the power source,
make certain that the inverter is well removed from
any potential source of flammable fumes or gases.
• In the event a continuous audible alarm or automatic
shut off, turn the inverter OFF immediately. Do not
restart the inverter until the source of the problem has
been identified and corrected.
23
OPERATING PRINCIPALS/SUMMARY
In Review.
• Never attempt to operate your Whistler inverter from
any power source other than a 12 volt battery or a
group of batteries that total 12 volts.
• Always make certain that the power cable terminal
connections Negative (-) to Negative (-) and Positive
(+) to Positive (+). Check these connections
frequently to ensure that they are secure.
• Make certain the rated power consumption of the
appliance or equipment you wish to operate is compatible
with the capacity of your inverter.
• If the rated power consumption of the equipment is in
the range of the maximum specified wattage of your
converter, test the inverter to ensure that it will operate
properly.
• Before attempting to use a battery charger see page 16.
• Before attempting to use medical equipment see page 6.
• Use the proper gauge cable (smaller the number, the
larger the cable) available to connect the inverter to
the power source.
• When operating the inverter with the engine off, start the
engine every 30 to 60 minutes and let it run for at least
10 minutes to recharge the battery.
22
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 25