Filter
Top Products
18
4. Fasten the positive (red) clamp to the positive battery post, and then
fasten the negative (black) clamp to the negative battery post.
5. Turn on the unit by holding the switch located on top of the unit
until 888 is shown on the display.
The digital display will show the battery voltage, indicating that the
Digital Inverter is operating normally and AC power is available at
the outlet.
6. Plug in the AC appliance you want to operate.
When not in use, always turn the inverter off by holding the switch until
the digital display turns off.
CAUTION
Make sure you connect red to red and black to black, and make sure you
screw the nuts on tightly.
XP_Digital_200-400-800.book Page 18 Wednesday, October 26, 2005 2:51 PM