Filter
Top Products
E
5-9
902025
N
701014
1) Adjust the trim angle so that the drive
shaft is at right angles to the water
surface or is trimmed in.
2) Open the emergency starter valve
located behind the silencer cover on
the front side.
214013
OPEN
CLOSE
3) Squeeze the priming pump two or
three times to feed fuel.
4) Open the throttle slightly without
shifting using the throttle control grip,
neutral throttle lever or free accelera-
tor. (It is necessary to change the
throttle opening slightly depending
on the engine temperature.)
After the engine starts, return the
throttle to the original position.
5) Set the MAIN SWITCH to “ON”.
6) Set the MAIN SWITCH to “START”.
cC
8 Do not turn the main switch to
“START” when the engine is running.
8 Do not keep the starter-motor turning
for more than 5 seconds. The battery
will rapidly become exhausted and it
will be impossible for the starter-motor
to start the engine. If the engine does
not start within 5 seconds, return the
main switch to “ON”, wait 10 seconds,
and then crank the engine again.
ON
START
OFF
701022
6H3-9-1M 5 3/11/02 9:07 PM Page 10