Filter
Top Products
2-3
E
1
Engine shut-off cord (lanyard)
Attach to wrist so that the engine stops if the
operator falls off the watercraft.
2
Engine stop switch
Push to stop the engine normally.
3
Clip
Insert into the engine shut-off switch to enable
starting of the engine.
Remove to stop the engine or prevent acci-
dental starting of the engine or unauthorized
use of the watercraft.
4
Quick Shift Trim System (QSTS) selector
Use to select the trim angle of the watercraft.
5
QSTS shift lock lever
6
Engine shut-off switch
Remove the clip to stop the engine and dis-
able it from starting.
7
Start switch
Push to start the engine.
8
Adjustable rearview mirrors
9
Multifunction meter
Use to check watercraft operation.
0
Shift lever
Use to put the watercraft into forward or
reverse.
A
Throttle lever
Use to accelerate and decelerate.
B
Tilt lever
Use to adjust the tilt of the handlebars.
C
Reverse gate
Controls direction of jet thrust when in reverse.
D
Stern drain plugs
Use to drain water in the bilge when the water-
craft is on dry land.
E
Jet thrust nozzle
Changes the direction of jet thrust according
to handlebar position.
F
Ride plate