Assemble the cable bracket to the clutch/idler
assembly using two 5/16" x 3/4" carriage bolts (K) and
5/16" nylock nuts (Y). Use the two front holes in the
cable bracket if your tractor has a 42" mower deck.
Use the two rear holes if your tractor has a 46" mower
Move the attachment clutch lever on the dash panel to
the disengaged (down) position.
Place the clutch/idler assembly on the fl oor on the right
Attach the tractor's clutch cable to the cable bracket.
Secure the cable housing guide (groove down) to the
cable bracket using the original collar and a 5/64" hair
Place a spacer (LL) on the welded pin on the idler arm.
Hook the end of the clutch spring over the pin and
secure it with a 1/4" washer (P) and a 5/64" hair cotter
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT (K)
5/16" NYLOCK
NUT (Y)
42"
DECKS
46"
DECKS
GROOVE
TRACTOR'S
CLUTCH CABLE
5/64" HAIR
COTTER PIN (NN)
1/4" WASHER (X)
SPACER (HH)
TRACTOR'S
CLUTCH CABLE
5/64" HAIR
COTTER PIN (DD)
1/4" WASHER (P)
SPACER (LL)
5/64" HAIR
COTTER PIN (DD)
Attach the two suspension arms to the rear of the
clutch/idler assembly using two 5/16" x 3/4" hex bolts
(C), 5/16" washer (Q) and 5/16" nylock nuts (Y) for
each arm. Place the arms on the outside of the frame
with the notches to the rear.
5/16" NYLOCK
NUT (Y)
5/16" x 3/4"
HEX BOLT (C)
5/16" WASHER (Q)
CABLE OPERATED MANUAL ATTACHMENT CLUTCH
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY
• Two different length drive belts are included with
your snow thrower. Tractors with manual attachment
clutches and dual front deck suspension brackets use
STOP
Did you choose the correct drive belt for
your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
Slightly loosen the hex bolt next to the fl at idler pulley.
Install the drive belt down between the hex bolt and the
fl at idler pulley with the fl at side of the belt against the
pulley. Retighten the hex bolt.
Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
