A SERVICE OF

logo

54 InfraStruXure InRow RC Service
Temperature Sensors
Tools
T20 Torx screwdriver, standard screwdriver, wire ties, wire cutters/scissors
Replacement, sensor connection
1. Remove power to the unit by disconnecting both power cords (feed A and feed B).
2. Lockout/tagout the unit being serviced.
3. Remove the rear door and the bottom air filter.
4. Use a standard screwdriver
to remove the plastic
pushclips securing the cover.
Remove the plastic cover
from the electronic
components.
Electrical
Hazard
This device may be connected to more than one input power source. Verify
that both feed A and feed B have been disconnected before attempting
maintenance.