Take Apart Display Cable - 108
Replacement Notes: To ensure that the display is
properly seated, reassemble it in the following sequence,
noting the precautions.
• Check that the display shield’s grounding tabs for the
microphone and the clutches are properly seated.
• Install the microphone and attach its connector.
• Install the display cable onto its 2 pins and slide it onto
the alignment guide.
• Wrap the display cable around the clutch and seat its
grounding tab on the end of the clutch.
• Reattach the kapton tape to the “Y” section of the display
cable.
• To prevent damage to the components on the display, lift
the bezel up slightly to reduce the load on the display.
Then connect the display cable to the display.
• Attach 4 pieces of new kapton tape where indicated by the
guide lines on the display shield.
