Apple Computer Hard Drive Manual

next previous

PowerBook G4 Hard Drive -

3. Make sure that the screws

(Figure 10A)

and rubber stoppers

(Figure 10B)

are in

place on the sides of the replacement drive.

4. Install the Mylar sheath

(Figure 10C)

so that it covers the bottom and left and right

sides of the drive. The sheath is directional and must be installed in the direction that

does not extend beyond the front of the drive.

5. Carefully install the ﬂex cable to the hard drive, if needed,

(Figure 10D)

. The

connector is keyed to ﬁt only one way.

Figure 10

6. Insert the right side of the drive ﬁrst, until the rubber stoppers ﬁt securely into the

holes in the bracket, and then insert the left side of the drive.

(Figure 11)

Note:

Make sure that the rubber stoppers do not fall off during installation.

Important:

Make sure that the flex cable does not get pinched behind the drive

during installation.

Figure 11